Outlet to usb block that twists5/5/2023 ![]() Now Square Register is ready to go! Please note that Square Register needs to be plugged into a power outlet to function. Press and hold the power button on the base of the Register display until the Square logo appears on the screen. Keep in mind, you should not attach the mounting plate to the Square Register before attaching to the plate to your countertop, you won’t be able to remove the plate from Register. Turn Register 90 degrees clockwise so it locks in place. Make sure the cleat is positioned in its slot. Place Register onto the mounting plate with the larger screen facing right. ![]() From the underside of your counter, place a thumb nut onto each thumbscrew and tighten until the thumb nut is flush against your counter. Position the mounting plate onto the holes you’ve drilled, then insert a thumbscrew into each hole. ![]() Use the drill and drill bit to make the four holes you’ve marked for the plate. You need a drill and the included tools: drill bit, thumbscrew, and thumb nut. Note: Maximum counter thickness is 1.75 inches (45 mm).Ģ. Make sure the raised cleat is on your side of the counter, not the customer’s side. Pick a spot on your counter for Register, position the plate, and use a pencil to mark the four screw holes on your counter. If you need to remove the plate, slowly pull the tabs on the adhesive strips until it releases. Adhere the plate to your counter in the desired position and press down firmly for 30 seconds. Make sure the raised cleat of the mounting plate is on your side of the counter, not the customer’s side. Remove the paper backing from the adhesive located on the underside of the plate. Using a damp cloth, clean the area where you want to secure Register. There are two ways to mount Register to your counter. Mount Square RegisterĬhoose a mounting setup. Plug one end into the customer display and the other end into the bottom of Register. ![]() Be sure to that the latch is completely released before removing the display as it can not be removed without the latch release. If you need to undock the customer display, press and hold the release latch located on the bottom of Register and lift the customer display out. Double check each side of the display, both sides need to be snapped in evenly for the customer display to function in the docked position. Press firmly on the bottom edges of the customer display until you hear it click to ensure it’s locked in place. Simply place the customer display back into its slot on Register. There are two ways to set up the customer display. With the power adapter cable, plug one end into the power adapter and the other end into a power outlet. Simply plug the cable into one of the micro USB ports located on the bottom of Register. Place the customer display aside for now-make sure you lay it down flat. Get ConnectedĬarefully lift customer display out of Register and remove the foam pad. Start by taking a quick look at what’s in the box. Let’s get your Square Register up and running. What’s In The Box Get Connected Set Up Your Counter Mount Square Register Power Up Connect to Your Network Creating Your Account and Signing In Connect Recommended Hardware Help and Support What’s In The Box
0 Comments
Leave a Reply. |